When using pneumatic tools, many people do not pay attention to the relevant knowledge of how to correctly use pneumatic tools, which leads to problems in use, especially for the safety of life. This is what pneumatic tool manufacturers do not want to see. Therefore, it is necessary for air tool manufacturers to popularize the basic knowledge of using air tools.

1. The reaction torque during the use of air tools, some air tools are likely to produce reaction torque when they are usually used, making the operator's body in a state of tension, affecting the balance of the body, and may pinch fingers. Air tool manufacturers remind you to be especially careful when using multi-axis nut lock equipment, screw drivers, ratchet wrenches, miter wrenches, rotors, tapping machines, pipe miter machines and other equipment. The operator should be careful to take precautions against undesirable reaction torque.

2, the use of pneumatic tools to choose the air compressor according to the actual needs, the correct choice of air pressure is relatively simple, generally 8 atmospheres, there are also high pressure such as 12 atmospheres (175Psi), if there is no special requirements, then generally 8 atmospheres are enough. The air flow of the air compressor is determined by the power. This is generally sufficient to supply a single tool. Before using air tools, be sure to read this manual. Only after fully understanding the content, can you use air tools in the workplace, and it must be strictly implemented.

In short, in the process of use, we must follow the operating steps described in the instruction manual, do not use air tools with high loads, do not exceed the maximum operating pressure, and often make air tools work in an environment exceeding the operating pressure, which will greatly reduce the service life of the tool itself. When frequently replacing tools or accessories, remove the pneumatic tools from the air source. Wear safety goggles whenever possible. Earplugs. Masks to maintain their own safety. Do not wear loose clothing during operation. Scarves, ties or hand ornaments to prevent danger from being entangled by moving or turning parts. When the pneumatic tool is connected with the high pressure air source, do not press the trigger when not in use. Ensure the condition of spare parts at all times, loose parts can lead to serious hazards. When replacing worn parts, use dedicated parts. Do not use air pressure pipe damage or impact. Never point the tool at yourself or others. Before use, check whether the air pressure pipe is weak or damaged. If the above conditions are found, please update immediately to maintain the safety of all nuts and screws, and ensure that all equipment is in a safe state.